Scooter Upgrade Kit Basic Edition

Does your scooter need an upgrade? Get a nice custom trick scooter with threadless headset, onepiece T-bar, compression system and 2x lightweight single clamps!

We have put together a kit of 5 parts that can upgrade the following threaded scooters, i.e. the kit upgrades your threaded scooter to a threadless one with the help of ICS compression technology.
A trick scooter with compression spins much better and is easier to tighten, and the onepice bar is stronger.

The kit consists of:
1x District Pro Threadless headset
2x District single clamp (32mm & 35mm)
1x Worx Royal Bar black onepiece T-bar (Alu. 35 mm outer)
1x Worx Royal pro scooter fork black threadless pro scooter fork
1x Worx compression kit.
Notice: Grips are sold separately, all grips fit this bar.

Scooters which can be upgraded with the kit:

• JD Bug Pro Scooter
• Razor Pro XX Scooter
• Razor Ultra Pro Lo Scooter
• Roces Kook Trick Scooter
• Slamm Rage Urban
• Grit Extremist Scooter
• Micro Bullet Street Pro 2.0 Scooter
• Grit Extremist Pro Scooter
• Madd Flow Scooter
• Micro Trixx scooter
• Razor Black Label 3.0 Scooter
• Razor Pro III Scooter
• Madd VX2 Pro 2012
• Razor Black Label 4.0 Scooter
• Madd VX2 Team Edition 2012
• Micro MX Park scooter

It is also suitable for:

• Slamm Mischief
• K2 Park Pro Scooter
• Shaun White Trick scooter
• Grit Elite Scooter
• Micro MX Pro OPB Scooter
• District V4 Complete scooter
• Lucky Crew Scooter
• Madd MGP Ninja Scooter
• Madd MGP Ninja 2012 Scooter
• Madd Nitro End of Days 2012
• Madd Nitro Extreme Scooter

*Other scooters may also be upgraded
*Handlegrips are not included, it is possible to use your old ones, or to buy a new pair (all of them fit).
*Required tools: Screwdriver+Hammer+Tape measure+Unbrako key and a little mechanical ingenuity ;)
-----------------------------------------------------------------------------------------------------------------------------------
Instructions:
General trick scooter assembly knowledge is required. We recommend reading our guide before you start, read Assembling a custom scooter here.
When you recieve the kit you first have to clean your old scooter and remove the old headcups that sit in the headtube.

1. Knock them out with a screwdriver and knock the new ones in with a hammer. Place a wooden block in between in order not to scratch the deck / new headcups.
2. Put the headset bearings in the new headcups.
3. Then measure how long is the new pro scooter fork going up into the bar measured from the top of the headset and up to the starnut, which is already inside the bar.
4. It must be so that the compression bolt can take hold of the starnut and streamline the whole system. If the starnut is not far enough up the bar, use a screw drive to knock it in deeper. If the starnut happens to be too far up inside the bar, there is an included replacement starnut you can use.
5. Tighten the compression so it spins the way you want it.